Here’s a easy-to-make and useful little stand that you can make with a scrap piece of just about any kind of wood.

The stand is about 16 1/2″ long, by 1 1/2 ” wide, by 1 5/8″ high and it holds fret wire that’s been cut for specific frets. Holes are drilled in the top to accommodate the pieces of fret wire. The sides are numbered from 1 to 22 corresponding to the frets that they fit. Useful little stand, especially if you’ve pulled some frets in order to do some inlay, or if you’ve cut fresh frets for a new guitar.

Fret Wire Stand - 3/4 view

Here are bigger pictures:
Click on a picture to show the full picture, then click on the arrows at the bottom right or left to advance or go back. Finally click on a picture again to exit the slide show.